New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
-
Specification: 11.0 to 14.5 V
Display: Htg. bC.ON/Htg.bC.OFF (alternating):
-
Specification: Between 0.0 to 12.0 V fluctuating
-
Switch off ignition.
If no voltage is present:
-
Remove inner plenum chamber cover, left
-
Connect VAG 1598/31 test box to control module wiring harness. Motronic Engine Control Module (ECM) -J220- is not connected by this action.
-
Check wiring for open circuit between test box and 6-pin connector according to Electrical Wiring Diagrams.
terminal 4 + socket 5
Wire resistance: Max. 1.5 Ohms
If no wiring malfunction is found:
-
Replace Motronic Engine Control Module (ECM) -J220-.
With Generic Scan Tool
Oxygen Sensor Heater For Oxygen Sensor Before Three Way Catalytic Converter (TWC), Checking
NOTE: When servicing terminals in harness connector of Heated Oxygen Sensor (HO2S), use only gold plated terminals.
Recommended special tools and equipment
-
VAG1526 multimeter or VAG1715 multimeter
-
VAG1594 connector test kit
-
Wiring diagram