New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
The battery is correctly installed when the center groove in the battery foot strip aligns with threaded hole in the battery carrier (arrows).
-
On batteries with hose for central venting make sure venting hose is not kinked. Only then can battery vent freely.
-
On batteries without hose for central venting make sure opening on upper side of battery cover is not blocked.
-
Install battery hold-down bracket and tighten bolt -3- to 22 Nm (16 ft lb).
-
Reinstall power steering fluid reservoir (install bolts -1- and -2-.),
-
Install positive (+) cable clamp onto battery positive terminal.
CAUTION!
-
Battery terminal clamps must only be installed by hand without force, this prevents damage to the battery housing.
-
Battery terminals must no longer be greased.
-
Tighten battery positive (+) terminal clamp securing screw to 6 Nm (53 in.lb).
-
Install negative (-) terminal clamp (battery Ground (GND) strap) to negative terminal on battery.
-
Tighten securing bolt to 6 Nm (53 in.lb).
CAUTION!
After installing, check if the battery is seated securely. If the battery is not secured properly, the following will result:
-
Shortened battery service life due to vibration damage
-
Battery cell and plate damage
-
Electrolyte leakage due to battery case damage
-
Poor collision safety
-
Clip cover with fuse holder into battery insulation enclosure and fold down onto top of battery.