New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
1
Circlip Mark after removing and insert in same position
2
Thrust plate Smooth side must face inner plates
3
Inner plate
^
Quantity - Refer to Specifications
4
Outer plate
^
Quantity - Refer to Specifications
5
Corrugated washer
6
Circlip
7
Spring supporting plate
^
With springs
^
Installation position refer to Fig. 2
8
Spring supporting ring
9
Piston
^
Sealing lips are vulcanized to piston
^
Moisten sealing lips with ATF before installing
^
Turn piston slightly when installing
10 Clutch housing
Fig. 1 Circlip -arrow-, removing and installing
^
Carefully press spring supporting plate down with 3267 just enough to remove and install circlip.
^
Be careful not to damage clutch housing ball valve.