New Beetle Turbo S L4-1.8L Turbo (AWP) (2002)
^
Press in tapered roller bearing outer race together with determined shim (in example 1.75 mm) while supporting transmission housing with thrust
piece 2050 directly under bearing support.
Perform check measurement
^
Determined shim installed.
^
Install measuring tools and secure with bolt (arrow) to transmission housing.
^
Set dial gauge (3 mm measuring range) to zero with 1 mm preload.
^
Loosen clutch housing/transmission housing securing bolts diagonally until output shaft is free to move in transmission housing.
^
If correct shim has been selected, dial gauge will indicate a value of 0.15 mm to 0.25 mm.
Output Shaft For 5TH, 6TH and Reverse Gear, Adjusting
Output shaft for 5th, 6th and reverse gear, adjusting
(Determining shim for output shaft)