Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing impact bar >
< Fitting rail to door window
Passat (B3)
Body
General body repairs
Rear door,sliding door,wing doors,central locking / Rear door
Repairing rear electric window regulators
Repairing rear electric window regulators
Repairing rear electric window regulators
–
Remove electric window regulator
→ Chapter
.
–
Fully unscrew securing bolts for gear mechanism cover
-arrows-
.
–
Pull off cable drum by hand in
-direction of arrow-
from gear mechanism housing by rocking lightly.
–
Pull off assembly cover from new motor in
-direction of arrow-
.
Note
Surfaces/parts coated with grease must not come into contact with dust or dirt. Add only genuine grease -G 00 450 02-.
–
Pull off drive gear in
-direction of arrow-
from gear shaft. Note spacer.
WARNING
Damping element
-1-
must locate exactly in recesses of cable drum.
–
Place drive gear
-2-
in cable drum, fit spacer
-3-
to drive gear.
–
Join motor for window regulator in
-direction of arrow-
with cable drum.
–
If gear mechanism housing cannot be joined with cable drum onto stop, alter position of drive gear by moving follower slightly until it engages.
–
Check correct position of cable on cable drum.
–
Screw in securing bolts and tighten in prescribed sequence (3 Nm).
Note
Perform functional check prior to installation.
Replacement of mechanical parts (linkage/cable) is performed in the same way.
Body
General body repairs
Rear door,sliding door,wing doors,central locking / Rear door
Repairing rear electric window regulators
Removing and installing impact bar >
< Fitting rail to door window