volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Display group 003 > < Display group 001

Passat (B3)

Evaluating display group number 001
   
Evaluating display group number 001
Display zoneDescriptionDisplayFault rectification
1Driver side airbag igniter -N95-Correct
End psn. earth
End psn. pos.




Too low








–  No fault present
–  Visual check of wiring
–  Check connectors of respective current circuit are seated correctly and at the same time observe display. If display changes to “correct”, erase fault memory
–  Pull ignition capsule connector off airbag unit
Display changes to “too high”
–  Renew airbag unit
Display remains on “too low”
–  Separate connector on coil connector with slip ring
Display changes to “too high”
–  Renew coil connector with slip ring
Display remains on “too low”
–  Renew wiring harness
     Continued on next page

   
Display zoneDescriptionDisplayFault rectification
1  Too high 
–  Pull ignition capsule connector off airbag unit
–  Fit ignition capsule connector to inert ignition capsule of -VAS 5056- → Chapter.
Display changes to “correct”
–  Renew airbag unit
Display remains on “too high”
–  Pull off connector between wiring harness and coil connector with slip ring
–  Connect test box -VAS 5056- to driver's circuit wiring harness instead of coil connector with slip ring → Chapter.
Display changes to “correct”
–  Renew coil connector with slip ring
Display remains on “too high”
–  Press button on -VAS 5056-
Display remains on “too high”
–  Renew wiring harness
     Continued on next page
2Front passenger side airbag igniter -N131-Correct
End psn. earth
End psn. pos.
too low









too high		No faults present
–  Visual check of wiring
–  Check connectors of respective current circuit are seated correctly and at the same time observe display. If display changes to “correct”, erase fault memory
–  Separate connector between wiring harness and adapter cable to airbag unit
Display changes to “too high”
–  Renew airbag unit
Display remains on “too low”
–  Renew wiring harness
–  Connect test box -VAS 5056- to passenger's circuit wiring harness → Chapter.
–  Press button on -VAS 5056-
Display changes to “too low”
–  Renew airbag unit
Display remains on “too high”
–  Renew wiring harness
3Not relevant  
4Not relevant  

   

Display group 003 > < Display group 001