Volkswagen Workshop Service and Repair Manuals > Passat (B3) > Body | General body repairs | Sliding roof | Sliding/tilting sunroof with glass panel | Adjusting glass panel for sliding/tilting sunroof (height adjustment)

Adjusting glass panel for sliding/tilting sunroof (height adjustment)

Parallel running of sliding/tilting sunroof OK.

–	Tilt glass panel open.

–	Fully push back sliding headliner.

–	Release trim frame and push back.

–	Move glass panel to zero position.

–	Loosen all four screws of glass panel (floating alignment in roof aperture).

–	To prevent wind noises, carry out front and rear height adjustment in accordance with illustrations.

Panel adjustment front:

-a- = 1 mm lower than roof outer skin

-Arrow- = Forwards

Panel adjustment rear:

-b- = 1 mm higher than roof outer skin

-Arrow- = Forwards

–	Tighten screws of glass panel (6 Nm).

–	Slide trim frame forwards and clip in (secured with clips in area of front guides and guided in rear area by lugs).

Volkswagen Workshop Service and Repair Manuals