volkswagen Workshop Repair Guides

Volkswagen Passat Workshop Service and Repair Manuals

Installing > < Removing and installing front door trim
Removing
Removing
   
–  Pull off adjusting knob -1- for mirror adjustment.
  Note
Illustration is for vehicles with electric mirror adjustment. (Manual mirror adjustment → Chapter).
  N70-0165
–  Lever out cover -1- from base of door puller -2-.
Vehicles with electric window regulators and /or electric mirror adjustment
  N70-0185
–  Separate connector -1- for front left or right window regulator switch -E40 bzw. E41- and connector -2- for mirror adjustment switch -E43-.
Vehicles with mechanical window regulators
  N70-0186
–  Unclip cover in -direction of arrow-.
–  Unscrew bolt -2- with lock washer.
–  Pull off crank.
–  Pull off sleeve -2- (front door only).
  Note
Installation position with window closed 45 ° ± 12 °.
Continued for all vehicles
  N70-0037
–  Remove cross-head screws -1-.
  N70-0187
–  Remove cross-head screws -1- and -2- on front and rear edge of door trim.
  N70-0188
–  Pull out door trim -1- at top from window aperture -arrow-.
  Note
If the trim cannot be pulled off in the area of surround -2- because of insufficient space, the surround should also be removed.
  N70-0190
–  Separate connector -1- for immobiliser warning lamp -K117- (driver side only).
–  Lift off door trim at bottom from retaining brackets.
  N70-0191

Installing > < Removing and installing front door trim