volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Tightening torques > < Notes on removing
4-Cyl. fuel injection engine (4-valve), Mechanics
Removing and installing engine
Notes on installing

Installation is carried out in the reverse sequence, when doing this note the following:

  • ‒ Check clutch release bearing for wear, renew if necessary.
  • ‒ Lightly grease clutch release bearing, release bearing guide sleeve and splines on input shaft with G 000 100.
  • ‒ Check whether the dowel sleeves for centralising engine/gearbox are in the cylinder block, install if necessary.
  • ‒ When lowering the assembly, ensure that clearance exists between assembly and drive shafts.
 
N10-0013
  • ‒ → When installing the engine mounting ensure that the recess on the rear console and the recess on the front console locates on the lugs of the bonded rubber mounting -arrows-.
  • ‒ Align engine mountings stress-free by rocking and then tighten.
  • ‒ Install hydraulic clutch slave cylinder:

=> 5-Speed manual gearbox 02A; Repair group 30; Servicing clutch release mechanism

  • ‒ Install selector mechanism:

=> 5-Speed manual gearbox 02A; Repair group 34; Servicing selector mechanism

  • ‒ Installing P.A.S. vane pump:

=> Running gear; Repair group 48; Assembly overview: vane pump, reservoir, hydraulic lines (vehicles with 4-Cyl. engines)

Vehicles with air conditioner:

  • ‒ Install air conditioner compressor:

=> Heating, Air conditioning; Repair group 87; Air conditioner with manual controls; Removing and installing compressor bracket - 4-Cyl. petrol engine

  • ‒ Install lock carrier with attachments:

=> General body repairs; Repair group 50; Body, front; Removing and installing lock carrier

  • ‒ Filling with coolant
  • ‒ Adjusting throttle cable => Page 20-10
  • ‒ Electrical connections and routing:

=> Electrical system; Repair group 97

  • ‒ Check headlight adjustment and adjust if necessary:

=> Maintenance

  • ‒ If necessary adjust gearchange cables:

=> 5-Speed manual gearbox 02A; Repair group 34; Servicing selector mechanism

  • ‒ Perform basic setting:

=> Digifant injection and ignition system (4-valve); Repair group 24; Digifant injection and ignition system; Performing basic setting

Vehicles 10.94 ▸

  • ‒ Match engine electronics control unit to immobilizer:

=> Digifant injection and ignition system (4-valve); Repair group 24; Digifant injection and ignition system; Matching engine electronics control unit to immobilizer.

Tightening torques > < Notes on removing