volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Renewing engine carrier rubber mounting > < Assembly mountings

Passat (B3)

4-cyl. fuel injection engine (cross-flow cylinder head)
Removing and installing engine
Aligning engine and gearbox

Aligning is only necessary when the engine and gearbox have been removed and additionally the sub-frame and engine carrier bonded rubber mountings have been loosened.
 
N10-0010
  • ‒ → Loosen bonded rubber mounting -A- (engine mounting) on sub-frame and console.
  • ‒ Loosen bonded rubber mounting -B- (gearbox mounting) on gearbox and sub-frame.
 
N10-0016
  • ‒ → Loosen front bonded rubber mounting on engine carrier and console.
  • ‒ Align assembly stress-free by rocking.
  • ‒ Tighten bolts again in the same sequence.
         Tightening torques

Renewing engine carrier rubber mounting > < Assembly mountings