Volkswagen Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Additional information and removal instructions for vehicles with air conditioner >
< Aligning engine and gearbox
Passat (B3)
Power unit
4-cyl. fuel injection engine (cross-flow cylinder head)
Engine assy,cylinder block,crankcase / Removing and installing engine
Renewing engine carrier rubber mounting
4-cyl. fuel injection engine (cross-flow cylinder head)
Removing and installing engine
Renewing engine carrier rubber mounting
‒
Fit engine support bracket 10-222A with legs 10-222A/1.
‒
Locate support bracket in lifting eye on left of cylinder head and take-up weight of engine.
‒
Remove engine carrier.
‒
→ Lever out distance bracket -2- from rubber mounting.
‒
Press out rubber mounting -1-.
‒
Observe rubber mounting -1- installation position.
‒
Fit new rubber mounting.
‒
Press engine carrier distance bracket into rubber mounting.
‒
Install engine carrier -4- and tighten securing bolts -3- to
80 Nm.
Power unit
4-cyl. fuel injection engine (cross-flow cylinder head)
Engine assy,cylinder block,crankcase / Removing and installing engine
Renewing engine carrier rubber mounting
Additional information and removal instructions for vehicles with air conditioner >
< Aligning engine and gearbox