Volkswagen Workshop Service and Repair Manuals

Special tools, workshop equipment, test and measuring appliances and auxiliary items required

• ◆ 10-222A Engine support bracket
• ◆ 10-222A/1 Support bracket legs
• ◆ 3180 Retainer
• ◆ 3277 Fitting tool

• ‒ → Pull H.T. cables off ignition transformer and unclip out of the H.T. cable guide -2-.
• ‒ Remove H.T. cable guide -2-.
• ‒ Pull off vacuum hose between intake manifold upper part and fuel pressure regulator.
• ‒ Remove intake manifold temperature sender from intake manifold upper part.
• ‒ Fit engine support bracket 10-222A with legs 10-222A/1.
• ‒ Locate support bracket 3180 in lifting eye on left of cylinder head and take-up weight of engine.

• ‒ Remove engine carrier.
• ‒ → Lever spacer -2- out of the rubber mountings -1- with a lever.
• ‒ Press out rubber mounting -1-.

Note:

Observe installation position of the rubber mounting -1-.

• ‒ Fit new rubber mounting -1-.
• ‒ Press engine carrier spacer -2- into the rubber mountings -1-.
• ‒ Install engine carrier -4- and tighten securing bolts -3- to
       80 Nm.