volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Dismantling and assembling fuel rail with injectors > < Removing and installing parts of the injection system
Motronic injection and ignition system (6-Cyl. engine)
Servicing injection system
Dismantling and assembling air cleaner
 
N24-0076
  • Air cleaner upper part
  • Filter element
  • Air cleaner lower part
  • O ring
    • ◆ Renew if damaged
  • Activated charcoal filter solenoid valve 1 (N80)*/**
    • ◆ On air cleaner
    • ◆ Activated charcoal filter system

=> Repair group 20; Removing and installing parts of the fuel supply system; Servicing parts of the activated charcoal filter system

  • Retaining ring
    • ◆ For solenoid valve 1
 
N24-0076
  • Connector
    • ◆ For air mass meter (G70)
    • ◆ 4 pin
  • Air mass meter (G70)*
    • ◆ Checking
  • Intake hose
  • Elbow
  • Hose
    • ◆ For idling speed stabilization
    • ◆ From silencer
      => Page 24-19 , item 14
  • Heater element (N79)
    • ◆ For crankcase breather
    • ◆ Only for certain countries
    • ◆ Arrow on heater element shows air flow direction
    • ◆ Resistance at ambient temperature (approx. 25 °C)
           Specification: 7...12 ω
 
N24-0076
  • Connector
    • ◆ 2 pin
    • ◆ For heater element (N79)
    • ◆ Check Lambda probe heating voltage supply between contacts 1 and 2 with ignition switched on:
           Specification:
           Approx. battery voltage
  • Crankcase breather valve
  • To intake manifold upper part
  • Rubber disc
  • Retaining ring

Dismantling and assembling fuel rail with injectors > < Removing and installing parts of the injection system