volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Instruments, GCI > < Removing and installing poly-V-belt pulley with freewheel

Passat (B3)

Installing poly-V-belt pulley with freewheel
Installing poly-V-belt pulley with freewheel
–  First remove installed poly-V-belt pulley → Chapter.
–  Insert multi-spline adapter 3400 in freewheel disc.
–  First screw freewheel pulley by hand onto alternator drive shaft to stop.
Before installing freewheel pulley, set up torque wrench as follows:
   
–  Release socket drive -1- and pull off grip -2-.
–  Turn torque wrench grip -2- 180° and reinsert socket drive.
–  Set turning direction of torque wrench to anti-clockwise at socket drive.
–  Set torque wrench torque setting to 80 Nm.
–  Fit 6 mm hexagon key into alternator drive shaft.
  N27-0036
–  Counterhold multi point adapter 3400 with 17 mm ring spanner and tighten freewheel disc to 80 Nm by turning alternator drive shaft anti-clockwise with torque wrench.
–  Clip protective cap onto freewheel pulley.
  N27-0037

Instruments, GCI > < Removing and installing poly-V-belt pulley with freewheel