volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

ABOUT US
Removing and installing multi-pin connector on back of relay plate > < Relay plate

Passat (B3)

Removing and installing relay plate
Removing and installing relay plate
  WARNING
Before working on the electrical system disconnect the battery earth strap.
  Note
The relay plate with fuse holder is located behind the dash panel on the left. Removal of dash panel trim → General body repairs, interior; Rep. Gr.70.
   
–  Press securing clips -1- on left and right of relay plate in direction of arrow until locking pins -2- at the clips are pulled out of the retaining arm recesses -4-.
–  Swing securing clips -1- forwards and pull off from pins -3- at relay plate.
–  Press left retaining arm -4- outwards until pin -5- is pulled out of arm and then detach relay plate.
During installation pin -5- and locking pins -2- must engage in retaining arm recesses.
  V97-3012

Removing and installing multi-pin connector on back of relay plate > < Relay plate