Passat L4-1.8L Turbo (AWM) (2004)
^
Push ABS wheel speed sensor -1- into wheel bearing housing unit by hand until it stops. Installation position: Lug -A- faces toward front on the
left-hand side and the rear on the right hand side.
^
Insert clip -2- for speed sensor.
Note: When routing ABS wheel speed sensor wiring note:
^
The ABS wheel speed sensor wiring -1- is to be routed next to the brake line -2- on both sides as illustrated.
On the left-hand side there must be a clearance of approximately 2 cm between the exhaust system heat shield and the ABS wheel speed sensor wiring.