Passat L4-1.8L Turbo (AWM) (2004)
/Page-2334012.png)
^
VAG1331 Torque wrench (or equivalent)
^
VAG1410 Torque wrench (or equivalent)
^
VAG1869/2 Brake pedal depressor
Note:
^
Install repair kit complete.
^
After replacing brake pads, depress brake pedal firmly several times with vehicle stationary so that the brake pads are properly seated in their
normal operating position.
^
To draw off brake fluid from the reservoir, use a bleeder bottle which is used only for brake fluid. Brake fluid is poisonous, NEVER siphon brake
fluid by mouth!
1 - Brake hose
^
Do not disconnect brake hose when changing brake pads
2 - Retainer
^
Bolt to brake caliper housing
3 - Spring clip
4 - Brake line, 15 Nm
^
Screw into brake caliper housing
^
Screw into brake hose, counter hold on brake hose hex.
^
Make sure that lugs are properly seated in retainer grooves.
5 - Hex bolt, 8 Nm
6 - Protective cap
^
Take off
^
Upper protective cap with cable holder for brake pad wear indicator
7 - Guide pins, 25 Nm
8 - Ribbed combi bolt, 190 Nm
^
Clean ribs if using again
9 - Brake carrier
^
Bolt to wheel bearing housing
10 - Bearing bushing
11 - Brake caliper
