Passat L4-1.8L Turbo (AWM) (2004)
/Page-2378002.png)
7 - Brake line
^
To left-rear caliper
^
Marked on hydraulic unit with -RL-
8 - Brake pressure sensor
^
Removing and installing, Refer to Powertrain Management, Brake Pressure Switch, Service and Repair
9 - ABS hydraulic unit
^
ABS Return Flow Pump -V39- and valve block must not be separated from each other.
^
Control module and hydraulic unit, disassembling and assembling, Refer to Hydraulic Control Assembly, Service and Repair
10 - Control module
^
Control module and hydraulic unit, disassembling and assembling, Refer to Hydraulic Control Assembly, Service and Repair
11 -Bolt, 3 Nm
12 - Circlip
13 - Buffer
14 - Bracket
^
Application
^
See Parts Supplier
15 - Hex bolt, 9 Nm
16 - Seal
17 - Tandem-brake master cylinder
^
Cannot be serviced. Replace as complete unit if malfunctioning.
^
Remove and install together with brake booster, Refer to Brake Master Cylinder, Service and Repair
18 - Self-locking nut, 49 Nm
19 - Bolt, T45 Torx, 25 Nm
20 - Brake fluid reservoir
21 - Cap
22 - Sealing plugs
^
Coat with brake fluid and press into brake fluid reservoir
23 - Bolt, 10 Nm
24 - Vacuum hose
^
Insert in brake booster
