Passat L4-1.8L Turbo (AWM) (2004)
-
Place T10071/5 on camshaft pin.
-
Slide sealing ring over guide sleeve onto camshaft pin.
-
Remove guide sleeve.
-
Press in sealing ring until stop using T10071/3 thrust sleeve. Use M8 x 60 bolt for this.
-
Insert notched shutter wheel for Camshaft Position (CMP) sensor into intake camshaft.
-
Install gear (with cone facing outward) and tighten mounting bolt to 25 Nm.
-
Install camshaft housing and tighten to 10 Nm.
-
Install upper portion of toothed belt guard.
-
Connect connector for Camshaft Position (CMP) sensor.
The rest of the installation follows the reverse of the removal procedures.