Passat L4-1.8L Turbo (AWM) (2004)
Fuel Gauge Sender: Service and Repair
Fuel Supply Sensor 3 -G237-, Removing and Installing
Fuel Supply Sensor 3 -G237-, Removing And Installing
(AWD Models)
Special tools, testers and auxiliary items required
-
Ring nut wrench 3218
-
Torque wrench V.A.G 1332
NOTE:
-
The fuel tank must not be more than 3/4 full.
-
Empty fuel tank if necessary.
-
Read safety precautions and rules of cleanliness before beginning work.
Removing
-
Check whether a coded radio is installed. If necessary, obtain radio anti-theft coding.
-
Switch off ignition and all electrical consumers.
-
Disconnect battery Ground (GND) strap, See Electrical Equipment, - Repair Group 27.
-
Open fuel filler flap briefly and then close again.
-
Remove luggage compartment floor cover.
-
Remove Fuel Supply Sensor 3 -G237.
-
Disengage 2-pin connector - arrow - carefully and remove.
-
Use ring nut spanner 3218 to remove union nut.
-
Remove gasket.