Passat L4-1.8L Turbo (AWM) (2004)
/Page-1258001.png)
Brake Pressure Switch: Service and Repair
Sender 1 for brake booster -G201-, removing and installing
The brake pressure sender can be found on the hydraulic control unit -1-.
^
The hydraulic unit -1- is turned 180° on the W8.
This work sequence is for all vehicles, except with W8 engine:
^
Unscrew coolant expansion tank -2- and place to one side with coolant hoses still connected.
This work sequence is for vehicles w/W8 engine:
^
Unscrew power steering reservoir -3- and place to one side with hoses still connected.
Continued for all vehicles
^
Pull connector -1- off brake pressure sensor -2-.
^
Place lint-free cloths under the control module and hydraulic unit.
^
Remove brake pressure sensor.
Installing
Installation is carried out in the reverse sequence
Tightening torques:
Brake pressure sensor .............................................................................................................................................................................................. 20 Nm
Bleed brake system, Refer to Brakes and Traction Control, Brake Bleeding, Service and Repair
