Passat L4-1.8L Turbo (AWM) (2004)
-
Remove bolts -.
CAUTION: Electrostatic charges may result in involuntary deployment of the airbag. Therefore, the mechanic must be electrostatically
discharged before disconnecting ignition - and Ground (GND) wires. This is done e.g. by briefly grasping the chassis or door striker.
-
Disconnect connector - from airbag unit -.
-
Pull off airbag unit - from backrest frame -.
Installing
-
Installation is the reverse order of removal.
-
Switch ignition on.
CAUTION: Make sure no one is in the vehicle.
-
Connect vehicle battery.
Drivers Side/Passengers Side Head-Level Airbag (Recaro Seat), Removing and Installing
Drivers Side/passengers Side Head-level Airbag (Recaro Seat), Removing And Installing
NOTE: Removal and installation is described for right side of vehicle. The same instructions apply for removal and installation for the left-hand side.
Removing
CAUTION: Observe safety precautions for working on airbags.
-
Remove Recaro seat.
-
Remove trim, backrest mounting bracket.
-
Remove seat side trim on door sill side.