Passat L4-1.8L Turbo (AWM) (2004)
Ignition Switch Lock Cylinder: Service and Repair
Lock Cylinder, Removing and Installing
Lock Cylinder, Removing And Installing
CAUTION:
Before beginning repairs on the electrical system:
-
Obtain the anti-theft radio security code.
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Disconnect negative (-) battery terminal.
-
When disconnecting and reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on
performing OBD program and electrical system function checks.
Removing
-
Disconnect battery.
-
Remove upper and lower steering column switch trim. Steering column switches, removing
-
Where applicable, carefully disconnect electrical connection for the induction coil for anti-theft immobilizer from lock cylinder.
NOTE: If equipped, the induction coil for anti-theft immobilizer is integrated with the lock cylinder and cannot be serviced separately.
-
Insert ignition key in lock cylinder and turn to "ON" position.
Position of key in lock cylinder:
1. Position "OFF"
2. Position "ON / DRIVE"
3. Position "START"
-
Insert steel wire (approx. 0 1.2 mm) in drilling next to ignition key -arrow-