Passat L4-1.8L Turbo (AWM) (2004)
^
Tighten mounting bracket bolts - arrows - and.
^
Loosen bolt for bearing bracket and rear axle until the nut and bolt can be turned by hand.
CAUTION: The connection at mounting bracket on rear axle must be tightened only when the vehicle is standing on its wheels!
Otherwise the rubber mounting will be stressed, resulting in a reduced service life.
Further installation is in reverse sequence to removal.
^
Install and tighten wheels.
After installing check position of steering wheel during a test drive.
If steering wheel is not in straight ahead position the front axle alignment must be checked!