Passat L4-1.8L Turbo (AWM) (2004)
^
Place engine/transmission jack V.A.G 1383 A with V.A.G 1359/2 under the subframe and apply slight counter pressure.
^
Remove bolts - 1 - and - 2 - at rear of subframe on both sides of vehicle.
A - Supporting wood blocks
^
Lower the subframe slightly with the engine/transmission jack V.A.G 1383 A.
^
Loosen hex bolt - 1 -.
^
Remove guide link.
Installing
^
Install guide link.
^
Lift subframe slightly using engine/transmission jack V.A.G 1383 A.
^
Tighten bolts - 1 - and - 2 - at rear of subframe on both sides of vehicle and.
A - Supporting block of wood
^
Tighten nut on joint pin.
^
Install new hex bolt - 1 - and new hex nut and tighten.
Note:
^
Only use inner holes - arrow -.
^
Push guide link inward while tightening.
Vehicles with all-wheel drive
^
Bolt driveshaft to transmission.
Continued for all vehicles
^
Install wheel and tighten Wheel mounting.