Passat L4-1.8L Turbo (AWM) (2004)
^
Press sleeve E-44-1
^
Press piece E-45
Special tools and equipment required
-
3 - Kukko 17/2 Separating device
Removing
-
Loosen hex bolt for drive shaft when vehicle is standing on its wheels (otherwise danger of accident).
-
Remove wheel and raise vehicle.
-
Unbolt drive shaft at flange shaft.
1 - Hex key head bolt or multi-point key head bolt
-
Disconnect ABS vehicle speed sensor wiring out of retainer on brake caliper -arrow-.
-
Disconnect ABS vehicle speed sensor from wheel bearing housing.
-
Remove brake carrier and brake caliper and tie to body with wire.
-
Remove brake disc and cover plate.
-
Remove nut -1-, take out hex bolt and remove both links -2- out upward.
-
The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
-
If the hex bolt cannot be removed from the wheel bearing housing, then the hex bolt and the links -2- must be pressed out of the wheel bearing
housing.
-
Remove hex bolt for drive shaft.
-
Swing wheel bearing housing out of the way.
-
Remove drive shaft from wheel bearing housing and tie up.
Note: Place transmission jack VAG 1383/A underneath (danger of accident from falling parts when removing the wheel hub and the wheel
bearing).