Passat L4-1.8L Turbo (AWM) (2004)
Removing hub
-
Install separating device -1- between wheel bearing housing and hub and pretension.
-
Installation position: Flat sides of plates face to wheel hub.
-
Install support -2-, hollow piston cylinder -3- with pull rod and special nut -4-.
-
Hold appliance firmly and remove wheel hub.
1. Separating device Kukko 17/2
2. Bell E-40
3. Hollow piston cylinder HKZ-15
4. Special nut E-8-214 and pull rod
5. High pressure hose with quick release coupling
Removing wheel bearing
-
Install press piece -1- with shoulder to bearing, press sleeve -2- with four stepped internal diameters to wheel bearing housing, hollow piston
cylinder -3- with pull rod and special nut -4-.
-
Operate pump and remove the wheel bearing.
1. Press piece E-5
2. Press sleeve E-44-1
3. Hollow-piston cylinder HKZ-15
4. Special nut E-8-214 and pull rod
Removing bearing inner race off hub
-
Install separating device -1- behind bearing inner race -2-.
-
Installing position: Chamfer on plates faces to bearing inner race.
-
Install support -3- and hollow piston cylinder -4- with pull rod, screw on special nut -5- and remove bearing inner race.
1. Separating device Kukko 17/2
2. Bearing inner race
3. Support E-40