volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

01V, 5 SPD. A/T (FWD)|Page 7867 > < 01V, 5 SPD. A/T (FWD)|Page 7865
Page 2
background image

Short description

The test is performed according to the overflow principle depending on ATF temperature.

The ATF level will vary according to the temperature of the ATF.

Checking ATF level at too low ATF temperature leads to overfilling.

Performing ATF level check when ATF temperature is too high will cause insufficient filling.

Over and underfilling lead to impaired functioning of transmission.

Test requirements:
^

ATF filler tool V.A.G1924 reservoir must be filled only with ATF permitted for automatic transmission 01V. ATF must not be mixed with other
oils.

^

Transmission not in emergency running mode, ATF temperature not above 30°C.

^

Vehicle on a flat surface

^

Selector lever in "P", let engine run at idle.

^

All electrical consumers and A/C system must be switched off.

^

Drain plug with sealing ring - 1 - must always be replaced.

^

O-ring - arrow - for ATF check plug - 2 - must always be replaced.

^

ATF filling height - 3 - changes with ATF temperature.

^

Protective cap - 4 - with openings for ATF filler tool V.A.G. 1924. If reservoir is engaged into one of the openings, protective cap must not be
pushed upward into oil pan while doing so.

VW ATF is available as a replacement part.

ATF level, checking

01V, 5 SPD. A/T (FWD)|Page 7867 > < 01V, 5 SPD. A/T (FWD)|Page 7865