Passat L4-1.8L Turbo (AWM) (2004)
/Page-1982013.png)
-
Unbolt flanged shaft bearing bracket -arrows-.
-
Install connector holder to flanged shaft bearing mounting.
-
Install speedometer sensor.
-
Install drive axle -1-.
-
With transmission installed, check gear oil in front final drive.
Vehicles with V6 engine
-
Install left-hand drive axle protective plate if installed as standard -arrows-. The third bolt cannot be seen in the illustration.
Continued for all vehicles
-
Install front wheels.
Front Final Drive Transmission Housing Seal, Replacing
Front final drive transmission housing seal, replacing, 01V, 5 SPD. A/T (FWD)
