Passat L4-1.8L Turbo (AWM) (2004)
/Page-2036007.png)
8. Cover strip
^
With 2 solenoids for Tiptronic switch -F189- and gear indicator
^
Solenoids must be fitted securely on cover strip
^
Removing and installing
9. Guide
^
Guides masking panel
^
Unclipping from cover molding -5-.
10. Mounting bushing
^
Secure in mounting bracket -22- with locking clip -11-
11. Locking plate
^
Secures mounting bushing -10- in mounting bracket -22-
^
Install with angled ends pointing toward inside of mounting bracket
12. Pull rod
13. Spring
14. Selector lever
^
With pull rod, coil spring, selector gate and Tiptronic spring mechanism
15. Stop buffer
^
Clip into cable lever -17-
^
Install with large contact surface toward selector lever
16. Detent
^
Clip into cable lever -17-
17. Cable lever
^
Secured in mounting bracket -22- with fulcrum pin -23-
18. Spring clip with roller
^
For gearshift positions
19. Spring clip with roller
^
For Tiptronic position
20. Frame
^
Clip onto mounting bracket
^
Install with ribbed side upward
21. Nut, 10 Nm
22. Mounting bracket
23. Fulcrum pin
^
Secures cable lever -17- in mounting bracket -22-
24. Locking pawl
^
For selector lever lock
25. Shift lock solenoid -N110-
^
Removing and installing wire for selector lever lock
^
Can be checked using "guided fault finding" with the VAS 5051
26. Fulcrum pin
27. Cover
^
With seal for mounting bracket
28. Nut, 10 Nm
29. Securing clip
^
Secures selector lever cable to cable lever -17-
^
Install with angled end forward and upward
30. Locking plate
^
Secures selector lever cable to mounting bracket
^
Angled ends points to end of selector lever cable
