Passat L4-1.8L Turbo (AWM) (2004)
^
Insert complete selector lever into selector mechanism housing.
^
Hook selector lever into cable lever at bottom and top.
^
Slide both bushings for selector lever into the selector mechanism housing at front or rear.
^
Install new securing plate for bushings into selector mechanism housing so that the angled ends point inward.
^
Press catch spring for Tiptronic position into its mount in selector mechanism housing up to stop.
^
Place selector lever in position "2".
^
Lay locking cable lever into selector mechanism housing and engage it noticeably in both bearing areas.
^
Check locking function of locking cable lever. In selector lever position "P", it must engage in the catch and lock the selector mechanism.
^
Place selector lever in Tiptronic position.
^
Set frame onto selector mechanism housing (ribbing points upward) and insert buffer stop into cable lever.
^
Install selector mechanism.
^
Check ignition key removal lock.
Selector lever, disassembling and assembling
^
Remove selector mechanism.
^
Remove selector lever.
Disassembling
^
Using a drift, drive out bearing pin for selector lever as shown in illustration.
^
Slide gate with Tiptronic spring with raised pull-rod out of the selector lever.
^
Release tension of compression spring and also remove pull-rod and compression spring from the selector lever.
^
Pry out gate cover on both sides.
^
Using a screwdriver, carefully pry out springs - 1 - and - 2 - and press piece (3 pieces) for Tiptronic spring - arrow
Assembling