Passat L4-1.8L Turbo (AWM) (2004)
^
Clean each time the oil pan is removed
^
Make sure entire surface contacts oil pan
6. Oil strainer
7. Gasket
^
pull off from oil strainer using Kukko puller 18/0
^
press onto suction collar of oil strainer
8. Bolt, 8 Nm
^
For mounting valve body: 1 bolt M6x30, 16 bolts M6x60
^
Observe tightening sequence
9. Valve body
^
Allocation according to transmission code letters original parts distributor
10. Bracket
^
for wiring harness hook in wiring harness fastened with bolts for valve body
11. Bolt, 6 Nm
12. Transmission Vehicle Speed Sensor (VSS) G38 / Transmission Output Speed (RPM) Sensor G195
13. Spacer sleeve
^
Height: 8 mm
14. Inner oil line
^
Always replace
15. O-ring Always replace coat with ATF and insert
16. Speedometer Vehicle Speed Sensor (VSS) G22
17. O-ring Always replace coat with axle oil and insert
18. Multi-Function Transmission Range (TR) Switch F125
19. Bolt, 8 Nm
20. O-ring
^
Always replace
^
coat with ATF and insert
21. Retaining clip
^
Always replace
22. Wiring harness
^
Transmission Fluid Temperature Sensor G93 is integrated into the wiring harness
^
Installation position of wiring harness connectors: Flat spot of rear collar faces toward oil pan; tabs on collar are horizontal.
23. Bolt, 6 Nm
24. Transmission Input Speed (RPM) Sensor G182
25. Spacer sleeve
^
Height: 20 mm
26. Bolt, 6 Nm
27. Bracket
^
for solenoid
28. Solenoid Valve 4 N91
^
With O-ring
^
Remove and install valve body to replace Valve body, disassembly and assembly sequence (transmission with hydraulic control E17)
^
Coat O-ring with ATF and insert
29. Solenoid Valve 3 N90
^
Without O-ring
30. Solenoid Valve 2 N89
^
Without O-ring
31. Bolt, 6 Nm
32. Bracket
^
for solenoid valve