Passat L4-1.8L Turbo (AWM) (2004)
-
Detach clutch pedal from master cylinder by prying out securing clip for pin with screwdriver -arrow 2- and pulling out pin -arrow 2-
-
Press clutch pedal securing clip -arrow 1- off pivot pin with a screwdriver.
-
Remove plug -arrow 2-
-
Press clutch and brake pedal pivot pin out to right, until clutch pedal can be removed.
-
If necessary press brake pedal securing clip off pivot pin with a screwdriver.
-
Take out clutch pedal and over-center spring.
Installing
The installation procedure is the reverse of the removal sequence, when installing note the following:
-
Align clutch pedal/brake pedal pivot pin so that it protrudes from mounting bracket on clutch pedal side (arrow).
-
Press clutch pedal onto stop and insert over-center spring in its seat on clutch pedal.
-
Now put clutch pedal in the pivot pin and push it to the left until securing clip cam be attached
-
Connect master cylinder to clutch pedal and engage securing clip for pin in clutch pedal
-
Do not tighten bolt -arrow 2- until both securing clips -arrow 1- for clutch pedal; clip for brake pedal (not visible) have been installed on the clutch
pedal/brake pedal pivot pin.
-
Adjust clutch pedal switch above clutch pedal.