Passat 2004 Transmission Repair: Clutch Pedal Assembly for 01E Manual Transmission
Clutch pedal and over-center spring, removing and installing, 012/01W, 5 SPD. M/T
Removing
^
Remove drivers side storage compartment.
Make sure that clutch pedal switch - 3 - is not pushed out of securing clip. Clutch pedal switch will be damaged and must be replaced.
In order to assure sufficiently secure fitting, clutch pedal switch - 3 - must not be installed more than once.
Release operating rod/master cylinder from clutch pedal as follows:
^
Position standard needle-nose pliers - 1 - into depressions of clutch pedal.
^
Press mount - 2 -.
^
Pull clutch pedal slightly into passenger compartment.
^
Pull operating rod and mount out of clutch pedal toward engine compartment - direction of arrow -
^
Press clutch pedal securing clip - arrow 1 - off of pivot pin using screwdriver.
^
Unthread bolt - arrow 2 -.
^
Press clutch and brake pedal pivot pin toward right until clutch pedal can be removed.
^
If necessary, press brake pedal securing clip off of mounting bracket using screwdriver.
^
Remove clutch pedal and over-center spring.