Passat L4-1.8L Turbo (AWM) (2004)
/Page-2133002.png)
1. Flywheel
^
Make sure centering pins are in place and seated correctly
^
Contact surface for clutch lining free of dirt, oil and grease
^
Install with white markings on flywheel - A - and pressure plate - B - pointing to each other (if present).
2. Clutch disc
^
Allocate according to Electronic Parts Catalog (ETKA)
^
Installation position at dual-mass flywheel: Clutch disc lining must make full contact with flywheel
^
Installation position at simple flywheel: Spring cage points to pressure plate
^
If present, the writing "transmission side" always points toward pressure plate and transmission.
^
Centering
^
Lightly lubricate splines
Note:
^
Clean input shaft splines and (in case of used clutch plates) clean hub splines. Remove corrosion and apply only a very thin coating of lubricant G
000 100 on input shaft splines. Then move clutch disc on input shaft back and forth until hub on shaft moves easily. Always remove excessively
applied grease.
3. Pressure plate
^
Checking ends of diaphragm spring
^
Check spring connection and rivet connections
^
Check wire ring
^
Install with white markings on flywheel - A - and pressure plate - B - pointing to each other (if present).
Note:
^
Pressure plates are protected against corrosion and greased. Only the contact surface may be cleaned, otherwise service life of clutch is
significantly reduced.
4. Bolt, 25 Nm
^
Loosen and tighten in stages and in diagonal sequence
