Passat L4-1.8L Turbo (AWM) (2004)
-
Mount assembly appliance 3139 and tighten plastic nuts.
Driveshaft with 60 mm tube diameter front and 70 mm rear
Note: Do not set assembly tool over balancing weights.
-
Mount assembly device 3139 with spacers 3139/3 and tighten plastic nuts.
Continued for all vehicles
-
Remove intermediate mounting securing nuts (arrows).
-
Check tightening torque for intermediate bearing securing studs.
-
Measure dimension -a-.
Left and right sides must be same.