Passat L4-1.8L Turbo (AWM) (2004)
/Page-2155005.png)
^
Screw hex bolt M10x10010.9 - 3 - into rear final drive.
^
To loosen bolts - 1 - for propshaft at front and rear, counterhold using a lever - 2 -.
^
Remove the three upper bolts on each propshaft constant velocity joint.
Vehicles without threaded hole in facing side of rear final drive
^
Lower vehicle.
^
Insert brake pedal depressor V.A.G. 1869/2.
^
Operate brake pedal using brake pedal depressor V.A.G. 1869/2.
^
Raise vehicle.
^
Remove lower three mounting bolts for each propshaft constant velocity joint.
^
Lower vehicle.
^
Remove brake pedal depressor V.A.G. 1869/2.
^
Raise vehicle.
^
Rotate both rear wheels in one direction and then rotate propshaft 12 (180°) additional turn.
^
Lower vehicle.
^
Insert brake pedal depressor V.A.G. 1869/2.
^
Engage the brake pedal using the brake pedal loading device.
^
Raise vehicle.
Continued for all vehicles
Propshaft with nominal dimension 60 mm at front and rear
When attaching and removing assembly tool, do not damage propshaft protective coating.
^
Do not set alignment fixture 4W dr. shaft 3405 on balance plates.
