Passat L4-1.8L Turbo (AWM) (2004)
Flange shaft/drive shaft seal, replacing, 01A, 5 SPD. M/T (AWD)
(Transmission installed)
Special tools, testers and auxiliary items required
^
Extractor lever VW 681
^
Installation drift 30 - 505
^
Press support 30 - 506 B
^
Engine/transmission jack VAG 1383 A
^
Floor jack mount
^
Multi-purpose grease
Removing
^
Disconnect driveshaft from transmission.
^
Slide driveshaft back to stop and tie up.
^
Disconnect exhaust system at catalytic converter.
^
Loosen all mounting bolts for torque support stop - arrow -.
^
Place Engine/transmission jack VAG 1383 A with floor jack mount under transmission.
^
Raise transmission slightly.
^
Remove right bonded rubber bushing - arrows A -.
^
Left transmission support must be removed from bonded rubber bushing - arrow B -.
^
If left bonded rubber bushings is identical to right one, it must also be removed.
^
Carefully lower transmission.
Flange for driveshaft must be located right below driveshaft.