Passat L4-1.8L Turbo (AWM) (2004)
Undamaged Side Window, Removing
-
Remove luggage compartment trim in upper area.
-
Remove C- and D-pillar trim.
-
Remove lower trim molding from window using a plastic wedge (only vehicles with trim molding).
-
Insert plastic wedge between sealing lip and window flange.
-
Loosen seal from window flange all around and spray in Cleaning solution D 009 401 04 (as a substitute for lubricant).
-
In area of C-pillar, two securing pins - arrows - are installed on window. Cut through se pins using a knife before cutting sealant bead and remove
from body.
-
Push cutting cord through adhesive sealant into vehicle interior using Awl V.A.G 1474/2 (from Separating device for bonded windows V.A.G
1474 A).
-
Using tube - 1 -, guide in cutting thread between seal and window flange (if cutting cord breaks, a cutting cable can also be used).
-
Pull through outer cord end inward and counterhold using Pulling grip V.A.G 1351/1.