Passat L4-1984cc 2.0L DOHC (9A) (1990)
Front Bumper, Removing/Installing
WARNING DO NOT drive vehicle without the front bumper and brackets installed. Subframe is NOT properly secured with bumper removed.
Removing
- Remove screws -1- securing air intake grill.
- Using screwdriver push down tabs A, B:
‹› tab A from reverse side
- Swing air intake grill down and out.
- Remove spreader clips on both sides.
- Disconnect wiring to fog, lights, if applicable.
- Remove bolts (arrows)
‹› 82 Nm (60.5 ft lb)
- Pull bumper assembly forward (driving direction) out of guides.
Installing
- Reinstall all components in reverse order of removal.