volkswagen Workshop Repair Guides

Volkswagen Workshop Service and Repair Manuals

Without Volkswagen Tester VAG 1551|Page 4672 > < Without Volkswagen Tester VAG 1551|Page 4670
Page 1
background image

Idle Speed: Testing and Inspection
With Volkswagen Tester VAG 1551

The air/fuel mixture is controlled by the CIS-E Motronic control unit. The purpose of the idle mixture adjustment is to assure that the oxygen sensor
system is operating near the middle of its control range.

Idle checks or adjustments will be valid only after the CIS-E Motronic fault memory is clear and the ignition timing is correct. Any faults stored in
memory must be corrected. Refer to COMPUTERS AND CONTROL SYSTEMS/TESTING AND INSPECTION.

Making these checks and adjustments together is very important in order to obtain satisfactory driveablity characteristics and emission levels.

TEST AND ADJUSTMENT CONDITIONS

1.

Engine oil temperature must be at least 176° F (80° C) and radiator cooling fan has operated at least once.

2.

All electrical consumers switched "OFF" (radiator cooling fan must not be running during checking or adjusting).

3.

A/C switched "OFF".

4.

Idle switch is functioning properly. For more information refer to COMPUTERS AND CONTROL SYSTEMS/TESTING AND
INSPECTION
.

5.

Fault memory must be clear of stored faults. If any are found, they must be corrected and then fault memory erased before proceeding. Refer to 
COMPUTERS AND CONTROL SYSTEMS/TESTING AND INSPECTION.

6.

The exhaust system must be free of leaks.

7.

There must be no engine vacuum leaks.

8.

The oxygen sensor must be connected and operating properly. Refer to COMPUTERS AND CONTROL SYSTEMS/TESTING AND
INSPECTION
.

9.

No fuel pressure measuring equipment connected.

10.

If injector lines were loosened or replaced, run the engine up to 3000 rpm several times and then allow to idle for at least 2 minutes before
performing any adjustments.

11.

Throttle cable adjustment must be OK.

TEST AND ADJUSTMENT SET-UP

1.

Put vehicle in PARK or NEUTRAL and set parking brake.

2.

Turn the ignition switch "OFF".

Checking Motronic Ignition

3.

Connect VAG 1367 engine tester using VAG 1367/8 inductive pickup, or an equivalent engine analyzer with strobe timing light and tachometer. 

CO Tester Hookup

Without Volkswagen Tester VAG 1551|Page 4672 > < Without Volkswagen Tester VAG 1551|Page 4670