Passat V6-2.8L (ATQ) (2004)
Trunk / Liftgate Motor: Service and Repair
Rear Lid Unlock Motor -V53- Wagon, Removing and Installing
Rear Lid Unlock Motor -V53- - Wagon From 10.00, Removing And Installing
Proceed as follows:
Rear lid lock carrier, removing
CAUTION:
-
Switch off all electrical consumers.
-
Switch off ignition and remove ignition key.
-
Remove screws -arrows A-, unclip trim -arrowsB- and remove trim.
-
Remove rear lock mounting screws -arrows- and partially pull out of rear lid.
-
Unclip cable -3-, disconnect electrical connection -2- and remove lock -1-