Passat V6-2.8L (ATQ) (2004)
Parking Brake Cable: Service and Repair
AWD/4 Motion
Parking brake cables (All Wheel Drive), removing and installing
Removing
^
Remove rear wheels.
^
Remove exhaust system (arrow).
^
Unscrew retaining nuts (arrows) from heat shield and remove.
Note: Adjusting the parking brake cables are located in front of the lower control arm.
^
Remove locking element-1-.
^
Screw in adjusting nut -2- until stop. To do this, counter-hold using an open-ended wrench (13 mm) in area -3-.
^
Push both cable sleeves -4- and -5- together.