Passat V6-2.8L (ATQ) (2004)
/Page-2423002.png)
^
Release grommet -1- in wheel housing.
^
Disconnect ABS wheel speed sensor harness connectors -2-.
^
Disconnect ABS wheel speed sensor wiring from retainers (arrows).
^
For vehicles with brake wear indicator separate the connector -1-.
^
Lift locking tab slightly on connector lower part -2- and then turn 90°.
^
Pull connector lower part out of bracket.
^
Pull ABS wheel speed sensor from wheel bearing housing.
Installing
^
Before inserting ABS wheel speed sensor, clean inner surface of bore hole and coat speed sensor with solid lubricant paste G 000 650.
^
Install ABS wheel speed sensor.
^
Install ABS wheel speed sensor wire in retainers and install grommet in wheel housing.
^
Insert brake wear indicator connector into bracket on brake caliper.
The brake wear indicator wiring must be routed between the brake carrier and brake line.
^
Turn wheels fully until left and right-hand lock, and check clearance to ABS wheel speed sensor wiring.
Checking, removing and installing rotor on front axle
^
Raise vehicle.
^
Remove wheel.
^
Disconnect ABS wheel speed sensor out of wheel bearing housing.
^
Check rotor for damaged or dirty parts by rotating drive axle.
^
If rotor is damaged, remove drive axle with rotor and outer constant velocity joint.
