Passat V6-2.8L (ATQ) (2004)
-
Check oxygen sensor heater on connector to Heated Oxygen Sensor (HO2S) terminals 1 + 2 for continuity
Specification: max. 200 Ohms
If specified value is not obtained:
-
Replace appropriate Heated Oxygen Sensor (HO2S).
-
Cylinder bank 1 (G39) item 27
-
Cylinder bank 2 (G108) item 18
If expected value is not obtained:
-
Check Ground (GND) connection of the appropriate oxygen sensor heater.
-
Switch ignition off.
-
Connect VAG1598/31 test box to control module wiring harness. Engine Control Module (ECM) is not connected.