Passat V6-2.8L (ATQ) (2004)
-
Check wires between test box and 4-pin connector to Engine Control Module (ECM) for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
Vehicles with engine code AHA
Vehicles with engine code ATQ
Continuation for all vehicles
-
Also check wires for short circuit to B+ or Ground (GND).
Specified value: Infinity Ohms
-
Check wire between 4-pin connector terminal 1 and Fuel Pump (FP) Relay -J17- for open circuit according to wiring diagram.
Wire resistance: max: 1.5 Ohms
If no malfunctions are found in wires:
-
Replace Motronic Engine Control Module (ECM) -J220-.
With Manufacturer's Scan Tool
Oxygen Sensor Heater For Heated Oxygen Sensors (HO2S) After Catalytic Converter, Checking
When servicing terminals in harness connector of Heated Oxygen Sensor (HO2S), use only gold-plated terminals.
Special tools and equipment
-
V.A.G 1551 Scan Tool (or VAG 1552 mobile scan tool) with VAG 1551/3 cable
-
VAG 1598/31 test box
-
VAG 1526 multimeter or VAG 1715 multimeter
-
VAG 1594 connector test kit
-
Wiring diagram
Test requirements