Passat V6-2.8L (ATQ) (2004)
Terminal 5 + socket 9
Terminal 6 + socket 34
Wire resistance: max. 1.5 ohms
Vehicles with transmission codes EKC, EKD (hydraulic control "E18/2")
-
Check wires between test box and 10-pin connector to Transmission Control Module (TCM) for open circuit according to wiring diagram.
Terminal 1 + socket 55
Terminal 2 + socket 36
Terminal 3 + socket 8
Terminal 4 + socket 37
Terminal 5 + socket 9
Terminal 10 + socket 34
Wire resistance: max. 1.5 ohms
Continuation for all vehicles
-
Also check wires for short circuit to each other.
Specified value: Infinite ohms
If no malfunctions are found in wires:
-
Replace Multi-Function Transmission Range (TR) Switch -F125-.
-
Erase DTC memory of Transmission Control Module (TCM). Diagnostic mode 4: Reset/erase diagnostic data. See: Testing and Inspection/Scan
Tool Testing and Procedures/With Generic Scan Tool/Diagnostic Mode 4: Reset/Erase Diagnostic Data
-
Generate readiness code. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes