Passat V6-2.8L (ATQ) (2004)
/Page-1588002.png)
^
Press retaining clips in direction of - arrows - using screwdriver.
^
Remove sensor wheel by prying out, alternating on sides.
Installing
Installation is in reverse order of removal. Note the following:
Installation position:
The drive peg of drive gear - A - faces seal - B - and locks into groove in differential.
The retaining clips - arrows - lock in circumferential groove in differential.
Always replace seal - B - and circlip - C -.
^
Drive in flange shaft using Needle Bearing Drift VW295.
^
Filling up gear oil
Tightening torques
