Passat V6-2.8L (ATQ) (2004)
Note: After installing Fuel Pump (FP) flange, check whether supply, return and vent lines are still clipped in at fuel tank.
Fig. 2 Checking bleeder valve
Lever in rest position: closed
Lever pressed in direction of arrow: open
Note: Before installing bleeder valve, unscrew cover from fuel tank.
Fuel Level Sensor 2 -G169-, Removing and Installing
Fuel Level Sensor 2 -G169-, Removing And Installing
Special tools, testers and auxiliary items required
-
Wrench for tank sensor 3087
-
Torque wrench V.A.G 1332
NOTE:
-
To remove locking ring, fuel tank may be a maximum of 1/4 full.
-
Empty right chamber of fuel tank if necessary.
-
Read safety precautions and rules of cleanliness before beginning work.
Removing
-
Check whether a coded radio is installed. If necessary, obtain radio anti-theft coding.
-
Switch off ignition and all electrical consumers.
-
Disconnect battery Ground (GND) strap.
-
Open fuel filler flap briefly and then close again.
-
Remove rear seat bench.
-
Remove Fuel Level Sensor 2 -G169-.
-
Carefully disconnect 2-pin connector - arrow - from Fuel Level Sensor 2 -G169- and remove it.