Passat V6-2.8L (ATQ) (2004)
Camshaft Position Sensor: Service and Repair
Parts of ignition, removing and installing
NOTE:
-
Cylinder bank 1 is located on right side in direction of travel.
-
Cylinder bank 2 is located on left side in direction of travel.
-
Engine Control Module (ECM) with harness connectors, item 6 .
1
Spark plug, 30 Nm
-
Type and spark plug gap, test data, spark plugs
2
Spark plug connectors with ignition wires
-
ignition coil, checking
3
Spacer sleeve
4
Rubber grommet
5
10 Nm
6
Ignition Coil-N152-
-
with power output stage
-
with marking for ignition wires, do not interchange
7
Connector
-
black, 5-pin
8
3-pin harness connector
-
Terminals are gold-plated
9
20 Nm
-
Tightening torque affects function of Knock Sensor (KS)
10
Knock Sensor (KS) 2 -G66-*
-
Cylinder bank 2
-
Terminals of sensor and connector are gold-plated
11
Knock Sensor (KS) 1 -G61-*
-
Cylinder bank 1
-
Terminals of sensor and connector are gold-plated